Installation Instructions

Your first step is to drill 2 holes in your tub; one low and one high.

This is to create a thermosyphoning current through your tub, where the cold water is pulled in the bottom and the hot water is pushed out of the top.

Your kit will come with 2 bulk head fittings. These fitting are what you use to seal the holes in your tub. Apply the bulk head fitting where the tank siding is as flat as possible to create a tight seal. If you have leaks you may need to get a caulk sealant.

Screw in your next fitting that will connect to the quick connect attachment.

You will now be able to connect your quick connect attachment to the tank. 

Lastly, tighten all of your clamps and fittings so no water will leak.

Fill your tub up with water, check for leaks, build a fire inside the coil, and watch as your tubs heats up!